Fiber Cement Siding Installation Instructions

Installing the siding like most siding you will install the fiber cement boards from the bottom up when using a traditional horizontal lap application.

Fiber cement siding installation instructions.

It s best to stagger the joints in each successive course to avoid noticeable patterns. Hardieplank lap siding. You will begin with a starter strip with weep holes that will allow moisture to readily escape. You can make your own fiber cement starter strip by ripping a piece of hardieplank lap siding into 1 1 4 inch strips.

Fiber cement siding should be installed 6 or more above the grade level of the house with a 1 2 gap between horizontal surfaces like decks steps or adjacent roofs. See below for a shopping list and tools subscribe to. Flash above doors and windows leaving a gap between the flashing and siding. Most fiber cement manufacturers make mounting blocks for lights electrical receptacles a c lines pvc venting etc.

Jaime prefers to use the vinyl mounting blocks typically used with vinyl siding. Hardiewrap weather barrier. As a homeowner you will work with a contractor who will facilitate the installation of your james hardie siding trim soffit wrap and flashing products including products with colorplus technology. And canada who are available to work with any contractor or builder.

How to stagger lap siding for walls longer than 12 feet you ll need to butt additional lengths of siding together. We have dozens of installation specialists throughout the u s. If you re hanging fiber cement siding you ll typically use fiber cement trim from the same manufacturer on areas like inward and outward corners. Remember that the siding is hard so be sure the nails are located at the right place before driving them.

This old house general contractor tom silva shares his secrets for working with fiber cement siding. Nails used to hang fiber cement siding shall penetrate at least 1 into the studs or the structural framing. They re cheaper and easy to install and you can cut the proper size hole in a plastic mounting block with a utility knife or a snips.