The bright copper wire inside copper cables can be a very sought after material when scrapping and recycling.
Fastest way to strip copper cable.
Poisoning the environment.
In this article we ll explore some common ways to strip copper wire and explain what sort of results each method produces.
First you should clean the corrosion off the wire using a combination of vinegar and salt.
Bring the water to a rolling boil.
Many people think the quickest way to get rid of the insulation surrounding copper wire is by burning it.
Having copper wire for recycling can be very valuable to strip for bare bright wire.
With copper prices meaning you re able to make money from selling the copper inside copper wire people working with the material such as electricians companies and individuals are more and more likely to be searching for the best ways to get good money for their scrap wire.
Attempt at own risk simply showing how we strip our copper wire not how to.
We plan to get wire stripper soon be safe always.
Hold the wire in one hand and with the wire cutters in the other hand slowly close the cutting head onto the wire about an inch from the end.
We have found that a lot of scrappers want to know the best ways to make more money from their copper and wire.
Allow the wire to sit in the boiling water for 10 minutes.
Mix these items in a bowl using only as much salt as will dissolve.
Boil the copper wire in water for 10 minutes.
So before you begin cleaning the copper wire it is best to strip the insulation to make sure you are getting all of the corrosion off in one sweep.
Dinosaur scrapper likely results.
Hold the electrician s knife at an angle of roughly 30 degrees to the wire at the point where you want to start removing insulation.
However this can lower the quality of your copper making it less desirable not to mention that it releases toxic fumes and gases into the air.
Burn the insulation off in a fire.
Instead set out your wire in the sun for a few hours and let the insulation warm up and soften.
Hold the wire with one hand tightly and use your free hand to grip the plastic on the wire and then start pulling.
Holding the knife at a shallow angle is critical because you want to cut through the insulation without having the sharp edge of the blade bite into the wire itself.
Carefully place your wires into the pot with the plastic casing still attached.
Using wire cutters wire cutters are designed to cut and strip wire making them the best tool for stripping copper wire.
Boil the water and put the copper wire that you want to strip into it.
Remove the copper wire from the water while wearing gloves.
The heat will warm up the plastic on the wire and make it easier to remove.
