Intended for use with auralex studiofoam products this pack of 24 ez stick pro tabs is designed to aid you in your quest to mount auralex acoustical treatment on your wall or ceiling.
Ez stick pro tabs.
The auralex ez stick mounting tabs provide a convenient solution if you re looking to install your auralex products in your studio or home.
4 remove one of the paper release liners from the mounting tab.
They are compatible with most auralex products and affix your acoustic treatment to walls and ceilings quickly and efficiently.
Apply the tabs on the rear of the panel near the outside edges oriented vertically for maximum holding strength.
Separate the ez stick pro mounting tabs from each other.
Ideal for walls ceilings and for other permanent installations the ez stick pro adhesive strips have a cure time of less than five minutes.
Read honest and unbiased product reviews from our users.
Use a citrus based adhesive remover to clean.
Peel and stick mounting tabs for acoustic foam.
With these easy peel and stick tabs you ll have your room treated in no time.
Overview hang your auralex without tubetak.
3 separate the ez stick pro mounting tabs from each other.
Perfect for products such as studiofoam q fusors metrofusors dst rs etc mounting them with the ez stick only requires simple steps of peel and stick.
Ez stick pro tabs are considered a permanent installation.
Avoid household cleaners as their surfactants will degrade the bonding power of the ez stick pro mounting tabs.
When you need to treat your jam room or studio you can mount your acoustic foam auralex s ez stick pro mounting tabs.
Each tab features an easy peel and stick application and helps achieve a permanent bond between your chosen piece of studiofoam and your wall or ceiling.
Apply the tabs on the rear of the panel near the outside edges oriented vertically for maximum holding strength.
Remove one of the paper release liners from the mounting tab.
Remove one of the paper release liners from the mounting tab.
When removing it is recommended to use a sharp knife to carefully separate the panel from the adhesive to minimize tearing.
Apply very firm pressure for 30 seconds in order to ensure the ez stick pro tabs properly adhere to the studio foam.
Not using adequate pressure will cause the ez stick pro tabs to fail.
Removing the panel after the adhesive has cured can result in some damage to the studiofoam and the mounting surface.
